Let me start off by saying by no means am I an expert with Klipper, or 3D printing. I don’t really know wtf I am doing half the time, I just manage to get it working – hah! I few days ago I decided to take the plunge into Klipper with my printer, a Monoprice Maker Select v2.1 with an SKR 1.3. I had been running Marlin 2.x on my printer and it was all setup and configured and working perfectly. I decided apparently that “working perfectly” wasn’t good enough, and I needed to break it. Enter Klipper. From what I gather now that that I have a 32 bit board I wont really gain much in the way of performance with Klipper vs if I still had the 8 bit Melzi. What you do gain is a much easier way to configure the firmware over compiling and flashing the board after every change. You just save a file and reboot.
Now I wanted to document the process for others in case it helps, and I figured this would be a quick build process and a quick write up. Heheh, I was wrong. I has now been a solid week of tweaking and configuring Klipper as well as a few days of writing this post and attempting to get it finished. Every time I do something else comes along that I feel I need to add to the process. Well, I finally got it all done – I think. Now what started off as a nice clean post turned into a ton of sections that didn’t jive. I’ve done my best to make it all flow and make sense, if I missed something let me know.
